research aggregates slag

Get Price And Support

Experimental investigation of surface modified EOF steel

Quarry dust obtained as an extractive waste from the granite stone quarries has been used as a blending material in this work. After several trials, it was found that a mix proportion of 1614 (cementquarry dustslag aggregate) was the most suitable mix ratio for the surface modification of the slag aggregates.

Get Price

Common Uses for Slag National Slag Association

According to studies as far back as 1927 by Penn State University, Ohio State University, U.S. Department of Agriculture, Auburn University, and Canadian research, Ag-Slag applications have been equivalent to limestone and dolomite in increasing crop yields at equal levels of fineness.

Get Price
[]

Can Steel Slag be used as an Aggregate in Concrete and

concrete containing steel slag aggregate possesses good mechanical properties, and slag, as a byproduct, is cheaper than aggregates, its practical use in portland cement concrete is currently a forbidden area in the construction practices. What is the practicality, where is the crux of converting research results into to real production, and

Get Price
[]

STUDY ON CONCRETE USING STEEL SLAG AS COARSE

coarse aggregate with steel slag enhances the strength. The results showed that replacing about 60 percent of steel slag aggregates for coarse aggregate and 40 percent of ecosand for fine aggregate will not have any adverse effect on the strength of the concrete. 1. Introduction Steel slag is an industrial byproduct obtained

Get Price
[]

Experimental Study on Concrete by Replacement of Fine

researchers are finding different materials to replace sand. One Fine aggregate normally consists manufactured sand. of the major materials is copper slag (CS), GGBS (Ground Granulated Blast Furnace Slag) and M-sand (Manufactured sand). Using different proportion of these copper slag and

Get Price
[]

5 Aggregate Specifications and Requirements

Slag Aggregates When slag is furnished as an alternate to natural aggregate, the payment is on a weight basis, adjustments must be made to compensate for the difference in specific gravity of the slag compared to the specific gravity of the natural aggregate. For any pay item less than 500 tons on a contract, no adjustment is made.

Get Price

Construction aggregate Wikipedia

Construction aggregate, or simply "aggregate", is a broad category of coarse to medium grained particulate material used in construction, including sand, gravel, crushed stone, slag, recycled concrete and geosynthetic aggregates. Aggregates are the most mined materials in the world.

Get Price

Characteristics and applications of iron and steel slag

Steelmaking slag Because of its hydraulic property and the large bearing capacity it can provide, steelmaking slag is used as a road base course material. With high particle density and hardness, this slag has superior wear resistance and for this reason is used as an aggregate for asphalt concrete.

Get Price
[]

Experimental Study on Concrete by Replacement of Fine

different level of fine aggregate with copper slag, GGBS and M-sand. II. PROPERTIES OF MATERIALS A. Cement A powdery substance made by calcining lime and clay mixed with water to form mortar or mixed with sand, gravel and water to make concrete. it is a binder, a substance

Get Price

Study of Granulated Blast Furnace Slag as Fine Aggregates

Jul 03, 2015 · The use of granulated blast furnace slag (GBFS) aggregates in concrete by replacement of natural aggregates is very promising concept because its impact strength is quite more than natural aggregate. Steel slag aggregates are already being used as aggregates in asphalt paving road m due to their mechanical strength, stiffness, porosity, wear

Get Price

Research on the use of Ferro-Chrome slag in civil

This material is being used for road construction, as aggregates in concrete industry, brick manufacturing, and in pavement construction as engineering fill and has recently been tried in cement. T1 Research on the use of Ferro-Chrome slag in civil engineering applications. AU Al-Jabri, Khalifa S. PY 2018/2/14. Y1 2018/2/14.

Get Price

Geometric Characteristics of BOF Slag Coarse Aggregate

The research showed that the use of BOF slag coarse aggregate in asphalt mixture has better performance than that of limestone. The mechanical properties of steel slag improve the moisture damage resistance and rutting resistance performance of asphalt mixture.

Get Price

Blastfurnace slag as aggregate for concrete Magazine of

Blastfurnace slag is an important source of dense aggregate for concrete. In an investigation lasting six years the Building Research Station has compared the properties of slag aggregates with those of crushed limestone and river gravel.

Get Price
[]

A Study on Non Destructive Tests of Concrete with

full replacement of fine aggregate with copper slag on the strength and behavior. In this experimental study, M20, M30, M40 grade concrete was used and the tests were conducted for different replacement of fine aggregate using copper slag as 0%, 20%, 40%, 60%, 80%, and in concrete.

Get Price

Research Pays Off Reclaimed Asphalt Pavement with Steel

Reclaimed asphalt pavement (RAP) consists of reprocessed HMA pavement material, such as asphalt and aggregates. RAP often contains high-quality, well-graded aggregates that are coated with asphalt cement but may include steel slag, a by-product of steel making.

Get Price

Experimental Investigation of Properties of Concrete with

So, this paper presents the results of an experimental investigation carried out to evaluate the mechanical properties of concrete mixtures in which fine aggregate (sand) was replaced with Copper Slag. The fine aggregates (sand) was replaced with percentages 0% (for the control mixture), 10%, 20%, 30%, 40%, 50%, 60%, 80%, and of Copper

Get Price

Research on Performance of Steel Slag and Porous Cement

Performance of Steel Slag and influence of the steel slag aggregate on physical and mechanical properties and durability of porous cement concrete were studied in this paper. Based on study of porous cement concrete properties, the paper puts forward several typical pavement structure forms in engineering application of porous cement concrete from finite element analysis method.

Get Price
[]

S. G. Research Services, L.L.C.

Section III Coarse aggregates for cement concrete was either gravel or crushed stone consisting of clean, hard, tough, durable, non-coated stone particles meeting 1. Not more than 1% by weight of clay and silt, 2. No clay coating adhering to particles, feeling slick to the touch when wet, 3. No clay lumps, 4.

Get Price
[]

Replacement of Fine Aggregate by Granulated Blast

Slag (GBFS), stone crusher dust, Quarry dust, Washed bottom ash, sheet glass powder etc. II OBJECTIVES . The aim of this study is to determine the strength of cement mortar, replacing fine aggregate with Granulated Blast furnace Slag (GBFS) by various percentages such as 0%, 50%, 60%, 70%, 80%, 90%, and .

Get Price

The use and advantages of slag voestalpine

Jan 10, 2014 · LD slag has been successfully used in Austria since the 1970s. Due to its positive technical characteristics, LD slag is used all over the world in road and railway construction and for engineering. The most common use is as an aggregate in the manufacture of asphalt. It is also successfully used as an aggregate for concrete.

Get Price
[]

Steel Furnace Slag in Hot Mix Asphalt Purdue University

Steel Furnace Slag in Hot Mix Asphalt . Long History of Use in Indiana Steel Furnace Slag use pre-dates 1988 Preferred aggregate for high volume surfaces for friction . Steel Slag Research at NCSC 2 Friction Aggregates steel slag and quartzite

Get Price
[]

5 Aggregate Specifications and Requirements

Slag Aggregates When slag is furnished as an alternate to natural aggregate, the payment is on a weight basis, adjustments must be made to compensate for the difference in specific gravity of the slag compared to the specific gravity of the natural aggregate. For any pay item less than 500 tons on a contract, no adjustment is made.

Get Price
[]

A STUDY ON THE ECONOMIC USING OF STEEL SLAG

bulk density of the steel slag aggregate higher than conventional aggregate by around 15-20%, thereby increasing the transportation costs in road construction, this can be considered as a main concern on using of steel slag aggregate in civil application (Emery, 2015).

Get Price

Measuring the Specific Gravity and Absorption of Steel

The research objective is to evaluate a new test procedure for determining the specific gravity and absorption of steel slag and crushed concrete, which are recycled and manufactured coarse aggregates, respectively. Steel slag and crushed concrete, unlike many coarse aggregates possess special physical characteristic such as many effective

Get Price
[]

Evaluation of Slag as aggregates in Asphalt Mixtures

In spite of the stated merits slag aggregates and slag asphalt mixtures possess, a very limited application of slag asphalt is practiced in the Swedish road construction industry. This study considered ten different slag aggregate materials from different Swedish slag suppliers/steel producers i.e., the

Get Price

10th EUROPEAN SLAG CONFERENCE

The 10th EUROPEAN SLAG CONFERENCE will take place in the KEDEA building (Aristotle University of Thessaloniki) in THESSALONIKI, GREECE, from October 8th to 11th 2019, jointly organized by the Laboratory of Building Materials of the Aristotle University of Thessaloniki, EUROSLAG and AEIFOROS S.A. The purpose of the 10th European Slag Conference is to share updated knowledge, ideas and research

Get Price

Ferrous Slag Market Size, Share And Forecast To 2023

According to industry experts, aggregates is expected to remain the key driver for ferrous slag market coupled with increasing demand for pipe bedding, agricultural and filter media owing to rapid industrialization especially in region such as BRIC which is anticipated to fuel the growth of ferrous slag

Get Price
[]

R E S E A R C H PAY S O F F Reclaimed Asphalt

with 92 percent steel slag aggregates and steel slag RAP recorded maximum expansions of 1.69 percent and 1.46 percent, respectively. A clear conclusion from the expansion tests was that RAP materials with slag aggregate that was partly coated with asphalt had much lower tendencies to expand than the steel slag aggregates, which

Get Price
[]

Effect of Recycled Aggregate and Iron Slag in Concrete

Ameri et al. (2012) used the steel slag from Zob-Ahan steel production factory in concrete. He replaced natural aggregates from the steel slag and performed compressive strength tests on samples containing slag ratios of 0, 25, 50, 75 and 100 % and cement contents of concrete 200, 300 and 350 kg/m3.

Get Price

() Experimental Study of Steel Slag Used As Aggregate

CONCLUSION In this research, the natural aggregate was replaced by SSA, 0% Slag 50% Slag 75% Slag Slag which is waste material derived from the steel industry, in

Get Price